3D Scalar Plot
Properties
3D scalar plots display components or absolute values of 3-dimensional
fields.
You may also display 2D cuts through 3D fields by choosing the option
3D
fields on 2D plane or the corresponding item from the .
Plot type frame
Contour:
All visible surfaces of your structure will be colored depending on the
selected field component value. In case of normal / tangential component
selected in the navigation tree, the color will be the field component
normal / tangential to the surface it is plotted on.
Isosurfaces:
Results in surfaces on which the selected component or absolute value
have a specific value. This value can be varied using the slider in the
Scaling frame.
See the Color
Ramp dialog box to modify the color mapping and the Specials...
dialog box for the option Draw contour
lines.
Note: This option is only available for hexahedral
meshes.
Bubbles: Use
this to visualize the scalar field
values in the volume. The selected field component values are
plotted in volume as bubbles with color and radius depending on the field
component and position in the space. Please note that plot type "Bubbles"
is not appropriate
for normal / tangential component selection in the navigation tree.
Phase/Animation (Time/Animation) frame
Plot amplitude/maximum:
For frequency monitors, plot the amplitude of the field vector / component
in each point. For time monitors, plot the maximum from all time steps,
in each point. If selected, movie will be disabled.
Plot average:
Plot the field vector length / component averaged over all phases. If
selected, movie will be disabled.
Phase / Time:
Specify the phase in degrees for frequency monitors or time in
your unit in case of time monitors.
Start / Stop:
Click here to start / stop the animation.
Settings鈥?
Opens a dialog box where you can specify field
animation settings like step width.
Scaling frame
For a contour plot, the slider scales the plot
linearly with a factor between 0 and 2. For isosurface plots, the slider
defines the value for which the isosurface is drawn. Thus, it influences
the size of the isosurface. For a bubble plot, it scales the size of the
bubbles.
Please note:
Scaling and logscale is disabled if clamp
to range is active.
log: Turns
on logarithmic scaling.
Strength: You
can vary the characteristic curve used for logarithmic scaling. Values
from 1.0e-6 to 100000 are allowed. A strength close to zero will result
in a nearly linear plot.
Inside/outside frame
Note: This frame is only available with tetrahedral
meshes.
Since every triangle is connected to two tetrahedrons,
you can choose a surface plot of a structure to be calculated by taking
into account the tetrahedrons lying either on the inside or outside surface
of the structure.
Plot inside field: For calculation use the tetrahedrons bordering
the structure surface on the inside.
Plot outside
field: For calculation use the tetrahedrons bordering the structure
surface on the outside.
Close
Closes this dialog box without performing any
further action.
Apply
Applies any changes to the visualization. Only
active if changes have been made.
Specials...
Opens a dialog box for special
settings. There, among other things, you may change some parameters
for scaling and plot quality.
Color ramp...
Opens a dialog box offering the possibility
to change the
coloring of the field plots.
Help
Shows this help text.
Example
3D scalar plot:
See also
2D/3D
Plot Overview, Post
Processing Overview,
3D
Vector Plot, 3D Scalar Plot, 3D Fields
on 2D Plane, 3D Scalar
Special Settings, Color
Ramp
HFSS视频教程
ADS视频教程
CST视频教程
Ansoft Designer 中文教程
|
淘宝官方店 
