Pick Face Mode
Shartcut: F
This mode enables you to select an area (a face) from your model. As
soon as an area is selected, it will be highlighted by a pattern of red
dots across its face.
You may select a face by double-clicking on it. Please note that an
area of a shape can only be picked on those shapes that are currently
selected, or when no shape is selected at all.
Use Pick
Face Chain to select a connected set of faces.
Measure cylindrical area radius
Whenever exactly one cylindrical area is selected
in the model, its radius will be displayed numerically in the .
Cancel this mode
You may cancel this mode by choosing Leave
Pick Mode ( )
from the
or pressing ESC.
Keep the pick mode
By default, the pick mode will be automatically
exited when a point is selected. This behavior may be tedious when a sequence
of points must be selected. To avoid the need for entering the pick mode
again, you may choose
Picks Picks Keep Pick Mode ( ). The pick mode will then remain active until
you cancel it as described above.
Deselect a picked face
Double-clicking onto a face that has already
been selected will deselected the face in question.
Clear all picks
You may clear the selection of all picked points,
edges or areas by choosing
PicksClear Picks ( ).
List of picked areas
You may obtain a list of all selected areas
by choosing
PicksPick ListsSelected
Faces... ( ).
Hotkeys
Some hotkeys are available to improve the handling
of commonly used pick operations. The corresponding hotkeys are noted
in the menus next to the commands (see Picking
Overview ).
See also
Pick modes: smart
picking, point, edge center point, circle
center point, circle
radius, area center
point, point
on face, edge, points
list, edges
list, areas
list.
Common operations based on picked areas: Face Modifications,Face Constraints,
WCS aligning.
HFSS视频教程
ADS视频教程
CST视频教程
Ansoft Designer 中文教程
|
淘宝官方店 
