首页 >> CST教程 >> CST2013在线帮助系统 |
Pick Face Chain ModeModeling: PicksPicksPick Face ChainThis mode enables you to select a connected set of faces from your model. A loop of faces can be terminated by a closed loop of connected edges. As soon as the faces are selected, they will be highlighted by a pattern of red dots.You may select a face chain by double-clicking on one of the faces. Please note that a face of a shape may only be picked when no other shape is currently selected.You may terminate the selection by picking a closed loop of edges before the pick face chain operation (see Picks Overview for details).Measure cylindrical area radius Whenever exactly one cylindrical area is selected in the model, its radius will be displayed numerically in the main plot window. Cancel this mode You may cancel this mode by choosing Leave Pick Mode () from the context menu or pressing ESC. Keep the pick mode By default, the pick mode will be automatically exited when a point is selected. This behavior may be tedious when a sequence of points must be selected. To avoid the need for entering the pick mode again, you may choose Modeling: PicksPicks Keep Pick Mode (). The pick mode will then remain active until you cancel it as described above. Deselect some selected face To remove some face from the face chain, choose Modeling: PicksPicks () and double click onto those selected faces that you want to deselect. Clear all picks You may clear the selection of all picked points, edges or areas by choosing Modeling: PicksClear Picks (). List of picked areas You may obtain a list of all selected areas by choosing Modeling: PicksPick ListsSelected Faces... (). Hotkeys Some hotkeys are available to improve the handling of commonly used pick operations. The corresponding hotkeys are noted in the menus next to the commands (see Picking Overview ). See also Pick modes: smart picking, point, edge center point, circle center point, circle radius, point on face, area center point, edge, points list, edges list, areas list, pick edge chain Common operations based on picked areas: Face Modifications,Face Constraints, WCS aligning. HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程 |
Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系:mweda@163.com |