2D Scalar Plot
Properties
2D scalar plots display components or absolute values of 2-dimensional
fields
. You may also create 2D cuts from 3D fields by choosing the option 3D fields on 2D plane or the corresponding
item from the .
Plot type frame
Contour: Results
in a plane with each point colored according to its field value.
Isolines: Results
in a plane with colored lines of constant field value.
Note: This option is only available for hexahedral
meshes with 'axis aligned control' mode.
Carpet: Results
in a hill plot with the height related to the field value. Color:
Colors the hill plot depending on the value.
See the Color
Ramp dialog box to modify the color mapping.
Note: This option is only available for hexahedral
meshes with 'axis aligned control' mode.
Phase/Animation (Time/Animation) frame
Animate phase/time: Activates the time animation of the selected
scalar plot.
Plot amplitude/maximum:
For frequency monitors, plot the amplitude of the field vector / component
in each point. For time monitors, plot the maximum from all time steps,
in each point. If selected, movie will be disabled.
Plot average:
Plot the field vector length / component averaged over all phases. If
selected, movie will be disabled.
Plot phase:
For complex vector fields plot the phase of the selected component. Not
available for abs. If selected, movie will be disabled.
Phase / Time:
Specify the phase in degrees for frequency monitors or time in your unit
in case of time monitors.
Start / Stop:
Click here to start / stop the animation.
Settings&ldots;:
Opens a dialog box where you can specify field
animation settings like step width.
Scaling frame
The slider acts depending on the selected plot
type. Contour: The slider affects
the mapping of field value to color. The maximum and minimum areas will
get bigger and more intensive colored for higher scaling. Isoline:
The slider has no effect so far. Carpet:
The slider position relates to the maximum height of the carpet plot.
Please note:
Scaling and logscale is disabled if clamp
to range is active.
log:
Turns on logarithmic scaling.
Strength:
You can vary the characteristic curve used for logarithmic scaling. Values
from 1.0e-6 to 100000 are allowed. A strength value close to 0 will result
in a nearly linear plot.
Cutplane control and location frame
This frame is only active if you plot a 2D plane
that is cut from a 3D field. You can do this by checking the option Results  3D fields on 2D plane or the corresponding
item from the
.
The options in these frames mirror the characteristics
of the respective frames in Cutting
Plane dialog exactly.
Close
Closes this dialog box without performing any
further action.
Apply
Applies any changes to the visualization. Only
active if changes have been made.
Specials...
Opens a dialog box for special
settings. There, among other things, you may change some parameters
for scaling and plot quality.
Color ramp...
Opens a dialog box offering the possibility
to change the
coloring of the field plots.
Help
Shows this help text.
Example
2D scalar plots (contour, isoline, carpet):
See also
2D/3D
Plot Overview, Post
Processing Overview,
2D Vector
Plot, 3D
Fields on 2D Plane, 2D
Scalar Plot Special Settings, Color
Ramp
HFSS视频教程
ADS视频教程
CST视频教程
Ansoft Designer 中文教程
|
淘宝官方店 
