HFSS中这样的错误如何解决???

我开始仿真都正确,但是将线的厚度由0.02mm改为改为0.01mm时候就出现了下面的 错误

Model Analysis ResultsEdge length ratio

Ref Number:17Two edges on a loop have very different lengths
ratio= 2.209945e-004
Face: id = 9698, on
Body: "Box16b" id= 9694
Face bounding box:
setcurpos [ 1.263000e+001, -5.568000e+001, -5.400000e-001 ]
setcurpos [ 1.263000e+001, -1.043000e+001, -5.300000e-001 ]
The longest edge:
type = straight
end1 = setcurpos [1.263000e+001, -5.568000e+001, -5.400000e-001]
end2 = setcurpos [1.263000e+001, -1.043000e+001, -5.400000e-001]
The small edge:
type = straight
end1 = setcurpos [1.263000e+001, -1.043000e+001, -5.300000e-001]
end2 = setcurpos [1.263000e+001, -1.043000e+001, -5.400000e-001]
Small edge


Ref Number:48This surface triangle edge is much smaller than the largest edge on the face
ratio= 2.318034e-007
The edge is on face : id = 8715, on
Body: "substrate" id= 8709
Face bounding box:
setcurpos [ 3.168000e+001, -6.318000e+001, -2.750000e+000 ]
setcurpos [ 3.168000e+001, 6.318000e+001, 2.750000e+000 ]
Vertex id = 356
setcurpos [3.168000e+001 ,-5.568003e+001, -5.300000e-001]
Vertex id = 358
setcurpos [3.168000e+001 ,-5.568000e+001, -5.300000e-001]


Small triangle

Ref Number:34This triangle is very much smaller thanthe largest triangle on this face
ratio= 5.292884e-010
The tri is on face: id = 8715, on
Body: "substrate" id= 8709
Face bounding box:
setcurpos [ 3.168000e+001, -6.318000e+001, -2.750000e+000 ]
setcurpos [ 3.168000e+001, 6.318000e+001, 2.750000e+000 ]
Vertex id = 318
setcurpos [3.168000e+001, 5.941997e+001 ,5.300000e-001]
Vertex id = 317
setcurpos [3.168000e+001 ,5.942000e+001 ,5.300000e-001]
Vertex id = 352
setcurpos [3.168000e+001 ,5.941999e+001, 5.333333e-001]