淘宝官方店     推荐课程     在线工具     联系方式     关于我们  
 
 

微波射频仿真设计   Ansoft Designer 中文培训教程   |   HFSS视频培训教程套装

 

Agilent ADS 视频培训教程   |   CST微波工作室视频教程   |   AWR Microwave Office

          首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档


Ansoft Designer / Ansys Designer 在线帮助文档:


Schematic Editor >
   Wiring Components       


Wiring Components

 

To start drawing a wire, do one of the following:

• On the desktop’s Draw menu, click Wire.

• Press CTRL+W on your keyboard.

• Click the desktop’s Wire icon .

• Move the mouse cursor over a component pin to display the crosshairs wiring cursor:

 

To draw connections:

• Click at the point where you want the wire to start, and move the cursor to extend the wire.

• As you move the cursor, click wherever you want to turn a corner.

• All connection points are highlighted in red.

 

To stop drawing a wire, do one of the following:

• Click, if the wire ends at a port or component pin.

• Double-click, if the wire does not end at a port or component pin.

• Press the SPACEBAR on your keyboard to terminate the wire operation and leave the net unselected.

• Press ENTER on your keyboard to terminate the wire operation and leave the net selected.

• Right-click, and then select Place and Finish.

 

The topics for this section include:

Selecting Components

Selecting a Wire

Displaying Wire Properties

Checking Connectivity

Nets, Buses, and Bundles

Net and Bus Auto-Naming

Cross-Probing Elements

 




HFSS视频教学培训教程 ADS2011视频培训教程 CST微波工作室教程 Ansoft Designer 教程

                HFSS视频教程                                      ADS视频教程                               CST视频教程                           Ansoft Designer 中文教程


 

      Copyright © 2006 - 2013   微波EDA网, All Rights Reserved    业务联系:mweda@163.com