淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

HFSS and Planar EM Simulators >
Excitations >
Working with Imported S-Parameter Data

Working with Imported S-Parameter Data

(Planar EM only)

An N-port is an external device with known S-parameters. In Designer it can be used to simulate devices such as amplifiers, diodes, capacitors, inductors, resistors, and previously simulated circuit or array subsections.

You can incorporate the circuit response of an N-port into the simulation of the overall structure by inserting it into your planar circuit. N-ports connect to edge ports defined on the side of transmission lines or metal structures.

In simulating structures containing N-ports, the ports of your Designer model are treated as open, internal ports first. The S-parameters of the model are computed using the full-wave simulator. The overall response of the structure is then obtained by connecting the S-parameters of the N-port to the S-parameters of the model at the appropriate connecting points using the circuit connection method.

The topics for this section include:

N-Ports with One Connecting Port

N-Ports with Two Connecting Ports

N-Ports with Three Connecting Ports

N-Ports with Four Connecting Ports

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com