Rotate Face Dialog

Modeling: ShapesExtrusionsRotate

Rotate a picked face around a picked edge. With this function you may create circles or helixes with the picked face as profile.

After you have created a new shape by rotation, the Shape Intersection Dialog box will open. There you may add the rotated shape to the original shape from which you picked the face.

If you have picked a face which can not be rotated, or when you have not picked any face, you will get to the Rotate Profile Dialog box.

Name

Specify the name of the new shape to be created by the rotate action.

Angle

Specify the angle in degree by which the face shall be rotated.

Height

To receive a helix you can specify the height of the helix.

Radius Ratio

This parameter influences the radius of the helix (height must be greater zero) depending on the height. You can set the ratio between the radius of the end point and the starting point in order to design a conical helix. If it is 1.0 the radius is constant over the height of the helix.

Segments per turn

This parameter influences the number of linear shape sections which are assumed for one turn. This option is useful if the analytical description (Segments per turn = 0) of the turn is not necessary to reach the desired accuracy. In this case a segmented approximation is the faster way (you can get sufficient results for most cases with 10 Segments per turn).

Examples

The three pictures below illustrate the results for different construction parameters.

 

image\helix1.gif

Segments per Turn : 0

Radius Ratio : 1.0

image\helix2.gif

Segments per Turn : 10

Radius Ratio : 1.0

image\helix3.gif

Segments per Turn : 0

Radius Ratio : 10

 

 

 

Component

Choose a new component from the select list. You can also create a new component by typing the name of the new component.

Material

Select the material to which this shape will be assigned from the list of previously defined materials or create a new material by selecting [New Material...]. You can also load a material from the material library by selecting [Load from Material Library...].

OK

Press this button to finally create the shape.

Preview

Press this button to create a preview image of the new shape. This option is very useful to check the settings before you actually create the shape.

Cancel

Closes this dialog box without performing any further action.

Help

Shows this help text.

See also

Brick, Sphere, Cylinder, Elliptical cylinder, Cone, Torus, Extrude Profile, Extrude Face, Rotate Profile, Loft, Shell, Coordinate systems, Transform.