淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

Optimetrics >
Setting up a Statistical Analysis

Setting up a Statistical Analysis

(System, Nexxim and Planar EM)

Following is the general procedure for setting up a statistical analysis.

Note

Statistical analysis requires an AC source. Attempting to simulate a Linear Network Analysis without an AC source may cause the simulation to fail, producing the error message: “Statistical Analysis failed — StatisticalSetup1”.

1. Before a variable can be included in a statistical analysis, you must specify that you intend for it to be used during a statistical analysis in the Properties dialog box.

2. On the Product menu, point to Optimetrics Analysis, and then click Add Statistical.

The Setup Statistical Analysis dialog box appears.

3. Under the Calculations tab, type the maximum number of iterations that you want Designer to perform in the Maximum Iterations text box.

4. Specify a solution quantity to evaluate.

5. In the Calc. Range text box, set the value at which the solution quantity will be computed.

6. Optionally, modify the distribution criteria that will be used.

A number of optional statistical solution setup options are available to be configured, if desired.

Other optional statistical solution setup options:

Modify the starting variable value.

Exclude variables from the statistical analysis.

Modify the values of fixed variables that are not being modified during the statistical analysis.

Request that Optimetrics solve a parametric sweep during a statistical analysis
(Nexxim and Planar EM only).

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com