淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

Dynamic Links and Solver On Demand >
   Dynamic Links >
       Adding a Dynamic Link N-Port from HFSS >
           Data Interpolation

Data Interpolation

Only S-parameter data from HFSS is linked to Designer circuits as “N-Ports.” Electric fields, magnetic fields, and antenna gain, etc., are not transferred.

You can choose to interpolate between HFSS design variations in the Designer circuit or simulate missing variations using HFSS:

• The interpolation scheme does not assume that the data lies on a rectangular grid and uses all of the available HFSS solution data.

If terminal data exists in the HFSS model, it is used by Designer, otherwise modal data is used:

• Multi-mode and multi-terminal ports in HFSS are shown as individual pins in Designer.

• S-parameter data from HFSS is normally re-normalized to 50 ohms in Designer due to the default port termination definition. (Data normally remains un-normalized in HFSS.) You can choose to renormalize the Designer port impedance to an HFSS port. See Renormalizing Ports Based on HFSS Data.

• Terminal data derived from differential pairs is not used by Designer.

Note

Differential terminal data in HFSS is transferred to Designer as underlying terminal data, which is not differential. For this reason, differential data plotted in HFSS may not agree with raw terminal data plotted in Designer.

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com