CST端口设置
若在CST中仿真一个微带结构,请问如何设置其端口?与HFSS的区别是什么?
谢谢
昨天在CST教程中看到的
Since a waveguide port extends the structure to infinity its transversal extension must be large enough to sufficiently cover the microstrip mode. On the other hand it should not be chosen excessively large in order to avoid higher order mode propagation in the port. A good choice for the width of the port is roughly ten times the width of the stripline. A proper height is about five times the height of the substrate.
微带线的端口设置一般端口宽度设置为微带线宽度的10倍,高度为介质高度的5倍。
不知是否正确。
多谢楼主提供信息,楼主可否上传一下CST的英文版教程?
端口可以设置一个面,大小上面那位说了。
教程在附件里。
重新上传附件。
对于端口大小的设置,说法不一,不管哪种,你最好先找个算例,验证一下设置的准确性。
不要太大已防止高次模,不能太小要足以覆盖端口模式,长度对端口阻抗影响显著。
多谢大侠
教程很有用..
多謝大大的分享^^
來去好好的學習 3Q