淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

Nexxim Simulator >
Variable Sweep >
Running Variable Sweeps from the Schematic Editor >
Setting Up a Frequency Sweep with Linear Network Analysis

Setting Up a Frequency Sweep with Linear Network Analysis

Nexxim linear network analysis supports a built-in sweep of frequency. (For DC analysis or transient analysis, no frequency parameters are predefined.) To perform a frequency sweep with linear network analysis, perform the following steps:

1. Under Circuit, select Add Nexxim Solution Setup. Select Linear Network Analysis for the Analysis Type and accept Frequency Domain for the Category. Click Next.

2. The Linear Network Solution Setup dialog box appears.

3. For Linear Network Analysis, the Sweep Variables panel has one frequency parameter (F). To set up a sweep of frequency, click Add.

4. The Add/Edit Sweep dialog box opens, with the selected frequency shown in the Variable field (which cannot be modified).

Sweep options are:

• Single Value (enter the value and units)

• Linear Step (enter Start, Stop, and Step values and units)

• Linear count (enter Start, Stop, and Count values and units)

• Decade count (enter Start, Stop, and Count values and units)

• Octave count (enter Start, Stop, and Count values and units).

5. Click Add.

6. If desired, add sweeps of local variables using the procedure given under Setting Up a Local Variable on a Component Parameter.

7. Click OK.

8. Complete the setup information (Output Quantities, etc.), then click Finish.

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com