淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

Nexxim Simulator >
Command Line Controls >
Configuration File

Configuration File

Simulation options can be provided in a configuration file (filename.cfg) specified in a -config_file option to the command line:

nexxim [-config_file=filename.cfg] [-o outputfile] input_file

If no config_file option is provided, the simulator looks for a file named cirsim.cfg in the directory where Designer/Nexxim is installed. If the configuration filename is not located in the install directory, its pathname must be provided with the filename. Within the configuration file, each option should be on a separate line, and can start with a prefix to identify the simulation tool or device category to which it applies:

option
Option for all analyses

dc.option
Option for dc analysis

tran.option
Option for transient analysis

hb.option
Option for harmonic balance analysis

lna.option
Option for linear network analysis

osc.option
Option for oscillator analysis

tvnoise.option
Option for time-varying noise analysis

s_element.option
Option for analysis of s-parameter element

See Invoking the Nexxim Simulator for details on the other command line entries. Refer to the individual help topics for details on the options recognized by each of the simulation tools.

When the same option has been set more than once, the following precedence is applied:

Command line options > netlist options > default (configuration file) options.

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com