Impedance and Calibration Line
Simulation:
Sources and Loads  Waveguide Port Define Lines... Add...
Impedance, calibration and polarization lines are
currently only available for models with tetrahedral mesh representations.
Mode number
Set the number of the mode here.
Line number
Set the number of the line here.
Line creation pick mode frame
Reverse orientation:
Toggle orientation of the line creation mode.
Start/Destination
and destination/start point: The line is created
by picking one start point and one endpoint
Start/Destination
point and face: The line is created by picking one start point and
a face.
Start/Destination
point and boundary: The line is created by selecting a boundary from
the Boundary drop down list and by picking the start/destination point.
Boundary: This
drop down list is only activated if the line creation pick mode is set
to Start/Destination point and boundary. Select here the appropriate
boundary as start location for the line
OK
Stores the settings and closes this dialog. You
are requested to define a line either by numerical input or by using the
pick tools.
If the line is created successfully the settings are added to the Mode
/ Impedance / Calibration / Polarization table in the Mode Impedance
and Calibration dialog box.
Cancel
Closes this dialog box without performing any further
action.
Help
Shows this help text.
See also
Mode
Impedance and Calibration, Waveguide Port, Waveguide
Port Overview
HFSS视频教程
ADS视频教程
CST视频教程
Ansoft Designer 中文教程
|
淘宝官方店 
