Pick Edge Chain Mode
Picks PicksPick Edge Chain
This mode enables you to select a set of connected edges from your
model. As soon as the edges are selected, they will be highlighted by
a thick red line.
You may select the edges by double-clicking on one of the edges. If
the picked edge belongs to more than one loop of edges, a small wizard
opens that will help to choose the appropriate loop. The edge selection
may be terminated by two previously selected endpoints (See Picks Overview for details).
Cancel this mode
You may cancel this mode by choosing Leave
Pick Mode ( )
from the
or pressing ESC.
Keep the pick mode
By default, the pick mode will be automatically
exited when a point is selected. This behavior may be tedious when a sequence
of points must be selected. To avoid the need for entering the pick mode
again, you may choose
PicksPicks Keep Pick Mode ( ). The pick mode will then remain active until
you cancel it as described above.
Deselect some selected edges
To remove some edges from the edge chain, choose
PicksPicks ( ) and double click onto those selected edges that you
want to deselect.
Clear all picks
You may clear the selection of all picked points,
edges or areas by choosing
PicksClear Picks ( ).
List of picked points
You may obtain a list of all selected points
by choosing
PicksPick ListsSelected
Edges... ( ).
Hotkeys
Some hotkeys are available to improve the handling
of commonly used pick operations. The corresponding hotkeys are noted
in the menus next to the commands (see Picking
Overview ).
See also
Pick modes: smart
picking, point, edge center point, circle
center point, circle
radius, area center
point, point
on face, area, edge,
numerical edge definition,
points list,
edges list,
areas list
, pick face chain
HFSS视频教程
ADS视频教程
CST视频教程
Ansoft Designer 中文教程
|
淘宝官方店 
