• 首页
• HFSS教程
• ADS教程
• CST教程
• 射频工程师培训
• 微波仪器操作培训
• 天线设计培训
• 射频专业基础课

Ansoft Designer / Ansys Designer 在线帮助文档：

Layout Editor User Guide >
Drawing a Model >
   Zooming and Panning the Layout View       

Zooming and Panning the Layout View

You can magnify (zoom in) or shrink (zoom out) the contents in the view window, or on a rectangular area in the view window. You can pan (scroll) the view in any direction.

Zooming In on the Window Contents

To magnify (zoom in on) the contents in the view window:

1. Click Zoom In on the View menu, or right-click in the schematic window and select Zoom In from the popup menu.

2. The view zooms in to a larger magnification. The absolute size of the model does not change.

3. Repeat the operation until the desired magnification is achieved.

Zooming Out on the Window Contents

To shrink (zoom out on) the contents in the view window:

1. Click Zoom Out on the View menu, or right-click in the schematic window and select Zoom Out from the popup menu.

2. The view zooms out to a smaller magnification. The absolute size of the model does not change.

3. Repeat the operation until the desired magnification is achieved.

Zooming In on a Rectangular Area

To magnify a specific rectangular area in the view window:

1. On the View menu, click Zoom Area, or right-click in the schematic window and select Zoom Area from the popup menu.. The cursor changes to a magnifying glass.

2. Draw a rectangle (or square) by selecting two diagonally opposite corners. This is the area where magnification will be increased.

The rectangular area is magnified in size and the cursor returns to normal. The absolute size of the model does not change.

Zooming In and Out Using the Mouse Wheel

You can also zoom the Layout editor display using the mouse wheel:

1. Shift, plus mouse wheel gives a coarse zoom about the current cursor position.

2. Shift-Alt, plus mouse wheel gives a finer zoom about the current cursor position.

Restoring a Previous Zoom View

After executing a zoom in or zoom out operation, you can return to the previous magnification by selecting Zoom Previous from the View pulldown or from the right-click popup in the layout window.

Panning the View

To pan (scroll) the view in any direction, hold down the SHIFT key while holding down the left mouse button. The view is attached to the cursor. While holding down the SHIFT key and left mouse button, move the cursor to pan the view in any direction. Release the mouse button to end the panning operation.

                HFSS视频教程                                      ADS视频教程                               CST视频教程                           Ansoft Designer 中文教程

      Copyright © 2006 - 2013   微波EDA网, All Rights Reserved    业务联系：mweda@163.com