淘宝官方店     推荐课程     在线工具     联系方式     关于我们  
 
 

微波射频仿真设计   Ansoft Designer 中文培训教程   |   HFSS视频培训教程套装

 

Agilent ADS 视频培训教程   |   CST微波工作室视频教程   |   AWR Microwave Office

          首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档


Ansoft Designer / Ansys Designer 在线帮助文档:


Layout Editor User Guide >
   Configuring a Stackup >
       Adding a Layer >
           Working with Dielectric and Metallized Signal Layers               


Working with Dielectric and Metallized Signal Layers

If you have multiple dielectric layers in your model, they must touch other dielectric layers or metallized signal layers. This prevents “pockets” of air from developing. If you have a signal layer between two dielectric layers, the dielectric layers must touch. The signal layer may overlap the two dielectric layers; however, a signal layer may not touch a metallized signal layer. You may create an air gap by defining a dielectric layer as air.

 

Note

Designer allows you to draw on all three primitive layer types: dielectric, signal, and metallized signal. Objects on dielectric layers are ignored in PlanarEM modeling, but they are displayed in Layout3D and they are exported (for example, to HFSS).

 

 




HFSS视频教学培训教程 ADS2011视频培训教程 CST微波工作室教程 Ansoft Designer 教程

                HFSS视频教程                                      ADS视频教程                               CST视频教程                           Ansoft Designer 中文教程


 

      Copyright © 2006 - 2013   微波EDA网, All Rights Reserved    业务联系:mweda@163.com