淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

Dynamic Links and Solver On Demand >
   Dynamic Links >
       Access to HFSS Output Variables from Designer and Nexxim >
           Dynamic Link Output Variables

Dynamic Link Output Variables

HFSS output variables can refer to either “regular” quantities (i.e. S-parameter based quantities) or “fields” quantities. In HFSS, a field-based quantity can only be evaluated for a given geometry, theta, and phi values. You must define these quantities in Designer using a manual override for dynamic link output variables.

Output variables for “regular” quantities from HFSS will have the following format in Designer:

<output_variable_name>(<dyn_link_comp_name>_ID)

where

• output_variable_name is the HFSS output variable name

• dyn_link_comp_name is the name of the dynamic link component in Designer

• ID is the ID of a particular instance of this component in Designer

Example: dbS11(Hfss1_11)

Note

It is assumed that “regular” output variables from HFSS are independent of the excitations used in HFSS.

HFSS output variables that refer to field quantities can be accessed in the Designer Reporter by overriding the standard output variable format as follows:

<output_variable_name>(<dyn_link_comp_name>_ID, geom='<hfss_geom_name>', theta=<text_value>, phi=<text_value>)

The override specifies the HFSS geometry to use to compute the output variable, theta, and phi.

Example: GainOut(Hfss1_11, geom='InfSphere1', theta='0deg', phi='50deg')

Notes

1. Output Variable data extraction will fail for field-based output variables if the three extra parameters are not defined.

2. The Output Variable override format can only be used for “file”' based output variable in HFSS.

3. Excitations are computed and “pushed” into HFSS prior to computing “field” based quantities in HFSS. Thus, the cost of extraction will be much greater for field-based output variables than for regular ones.

4. You can set up Designer sweeps that do not match the HFSS solution sweep used at simulation time. In this case, the output variable data may not be available across all Designer data points.

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com