下周要去NOKIA面试，大家帮帮忙！

first of all, what specifications do RF engineers care about? NF, IIP2, IIP1, ACPR, P1dB, Gain and so on.
And what are the exact meaning of them? I suggest you pay more attention on the specifications for a cascaded system, like what is the NF for a RX front-end chain with an attenuator.
Second, what are the frequently used methods for measuring these specifications. For example, what are the 3 approaches to measuring the NF, compare their merits and drawbacks. I think you should be able to draw the block diagrams of measurement setups. Plz keep in mind that the cable loss deserves your attention.
Third, be familiar with the basic operation of basic equipments, such as VNA, Spectrum Analyzer, Osciloscope, Signal Generator, Noise Analyzer and so on. If I were the interviewer, I would lead you to the Lab and ask you to establish some setup and do the measurements.
If you are unware of somethings mentioned above, refer to the Agilent's Website for helps. There are many valuable materials about RF measurement there.
Good Luck！
+3 RD币

[此贴子已经被Bug于2007-9-24 14:16:58编辑过]

我也在ＮＯＫＩＡ工作．请问你到北京还是?

thank you very much for your applied advice and your warmly help.

To openzhx:
呵呵，我也是去北京

To zaomy:
Could you give some basic material about RF. Just like the one you refer to. Eg. what are the exact meaning of NF, IIP2, IIP1, ACPR, P1dB, Gain and so on. Thanks a again for you honestly help！

To zaomy:

My email address:gfqgenius@126.com
Best regards

You are welcome！
plz read Razavi's book "RF Microelectronics", where you will find what you want.

Good Luck！

i am wrok for noika company at dongguang,i am glad to see you .can we make friends ?

真幸运！我工作时怎么没有这种机遇呢

why your are speaked English? Could you are foreigners?

VERY WELL, I'LL PRACTISE MY ENGLISH HARDLY.NOKIA,I'LLCOMMING SOON.

高处不胜寒啊！

Because the "Fourth" point is that you should learn English well, not only read and write but also in oral .

I want to join NOKIA for a long time~~~~

这位兄弟英语说的太......

so many str baby so many str english