CST MWS网格问题
我当时没有修改 直接计算的 应该是有些网格不联系 系统自动填充pec
CST MWS帮助文件《Mesh Problem Handling》:
"xxx" mesh cells are represented in staircase mode and have been filled with PEC/PTC.
"yyy" mesh faces are represented in staircase mode and have been filled with PEC/PTC.
Depending on the chosen hexahedral solver this warning might appear. It means that within a mesh cell or a mesh face a certain geometrical configuration cannot be used to run the solver correctly. Therefore these cells or cell faces are filled with PEC or PTC depending on the chosen problem type. However, in many cases these filled cells do not influence the simulation results significantly. The staircase based cells can be seen in the mesh view.
Solution:
Please make sure that the mesh is not too coarse at locations where the staircase based cells appear.
Depending on the chosen problem type, please activate the "Use TST cells" checkbox if provided in the "Mesh Properties - Hexahderal->Specials...->Advanced" dialog box.
哦,知道了,谢谢
谢谢,知道了
相关文章:
- 大虾们谈谈网格设置的原则和步骤。 (05-08)
- 如何在给定的一个小区域内设置合适的网格密度? (05-08)
- 请教大家一个问题?(关于网格密度) (05-08)
- 基于能量的网格加密和自适应专家系统网格加密有什么区别? (05-08)
- 请问高手:怎么样划分网格啊? (05-08)
- CST MWS频率设置与网格的划分问题 (05-08)