ADS2011仿真出现错误
05-08
看英文的意思是我的Port没放到边缘地方 ,但我尝试了很多次,都没放到边缘处
仿真下来都错误了。
不知道谁有什么办法解决这个问题呢
--- WARNING -------------------------------------------------------------------
Pin P2 is positioned on more than one edge.
Move the pin away from any unintended edges.
-------------------------------------------------------------------------------
--- WARNING -------------------------------------------------------------------
Pin "P1" on mask 2 is not fully connected to a
conductive part of the design.
-------------------------------------------------------------------------------
--- WARNING -------------------------------------------------------------------
The port setup needed to be corrected:
Calibration will not be used for port "P1" (pin
"P1" is not on the edge between a conductive and
a nonconductive region).
-------------------------------------------------------------------------------
Generating mesh at 1.1 GHz...
--- ERROR ---------------------------------------------------------------------
At least one pin or bondwire end is not fully
connected to a conductive part of the design
(see details above).
This setup is invalid for a Momentum simulation.
-------------------------------------------------------------------------------
仿真下来都错误了。
不知道谁有什么办法解决这个问题呢
--- WARNING -------------------------------------------------------------------
Pin P2 is positioned on more than one edge.
Move the pin away from any unintended edges.
-------------------------------------------------------------------------------
--- WARNING -------------------------------------------------------------------
Pin "P1" on mask 2 is not fully connected to a
conductive part of the design.
-------------------------------------------------------------------------------
--- WARNING -------------------------------------------------------------------
The port setup needed to be corrected:
Calibration will not be used for port "P1" (pin
"P1" is not on the edge between a conductive and
a nonconductive region).
-------------------------------------------------------------------------------
Generating mesh at 1.1 GHz...
--- ERROR ---------------------------------------------------------------------
At least one pin or bondwire end is not fully
connected to a conductive part of the design
(see details above).
This setup is invalid for a Momentum simulation.
-------------------------------------------------------------------------------
你是在
亲们,知道为啥了没
相关文章:
- 如何通过ads进行有源电路的版图仿真? (05-08)
- ADS仿真的一个体会 (05-08)
- ADS和HFSS如何协同仿真? (05-08)
- 请教:ADS2004仿真腔体滤波器的模型 (05-08)
- 大家知道该如何用ads仿真 一个移相器吗 ? (05-08)
- ADS 仿真微带功分器时,薄模电阻要设在哪一层? (05-08)
射频专业培训教程推荐