ADS仿真噪声系数时遇到个问题
05-08
Warning detected by hpeesofsim during SP analysis `SP1'.
The simulation temperature (25.0 C) is not the same as the IEEE standard noise temperature (290 K or 16.85 C) in the noise analysis `SP1'.
If the simulation temperature is not equal to the IEEE standard temperature, then the loss and the noise figure will not agree for a passive circuit.
The `Temp' parameter on the Options item can be set to 16.85 C to eliminate this warning message.
请问这个仿真温度怎么设置啊?
The simulation temperature (25.0 C) is not the same as the IEEE standard noise temperature (290 K or 16.85 C) in the noise analysis `SP1'.
If the simulation temperature is not equal to the IEEE standard temperature, then the loss and the noise figure will not agree for a passive circuit.
The `Temp' parameter on the Options item can be set to 16.85 C to eliminate this warning message.
请问这个仿真温度怎么设置啊?
用户被禁言,该主题自动屏蔽!
谢谢
相关文章:
- 如何通过ads进行有源电路的版图仿真? (05-08)
- ADS仿真的一个体会 (05-08)
- ADS和HFSS如何协同仿真? (05-08)
- 请教:ADS2004仿真腔体滤波器的模型 (05-08)
- 大家知道该如何用ads仿真 一个移相器吗 ? (05-08)
- ADS 仿真微带功分器时,薄模电阻要设在哪一层? (05-08)
射频专业培训教程推荐