microwave office 的错误
05-08
论坛里各位使用Microwave Office的高手朋友,
我在画完电路图后,出现以下的错误,
Simulating Schematic 1
W3: Equation Error: Variable not found W@3
Simulator : Error during linear simulation of Schematic 1->W3:Value not available
是软件安装的问题吗?还是电路参数本身没有设置对才发生的错误?
我在画完电路图后,出现以下的错误,
Simulating Schematic 1
W3: Equation Error: Variable not found W@3
Simulator : Error during linear simulation of Schematic 1->W3:Value not available
是软件安装的问题吗?还是电路参数本身没有设置对才发生的错误?
电路错误,不是软件问题
为什么是电路错误?
电路估计是不完整!
设置不对
是你的电路画的有误,两根微带线连接处的宽度不一样,改成一样的宽度就可以解决问题了。
相关文章:
- microwave office电路图能不能转为protel99se版图(05-08)
- microwave office (05-08)
- Microwave Office 2008 及其 Po Jie 方法 (05-08)
- microwave office 试验教程.pdf (05-08)
- AWR -Microwave Office资料下载 (05-08)
射频专业培训教程推荐