co-simulation仿真时出错谢谢各位指点

联合仿真时出错：
error：
port 21 does not resolve to a single face
warning：
could not resolve port 21
error：
port 25 does not resolve to a single face
warning：
could not resolve port 25
warning：
if the geometry contains lines that are within 1.25 degree of parallel
they will be treated as parallel because the layout resolution is relatively
coarse for this geometry，please increase the layout resolution if this causes problem。
generating mesh at 4.8GH
warning：
unable to correctly process port19
error：
via may not coincide withport or touch port。
please modify geometry

各位帮忙看看谢了

这么冷清

错误一：端口21设置为内置端口，你的接地孔搞偏一点，现在已经顶到端口了