淘宝官方店     推荐课程     在线工具     联系方式     关于我们  
　
　

微波射频仿真设计   Ansoft Designer 中文培训教程   |   HFSS视频培训教程套装
　

Agilent ADS 视频培训教程   |   CST微波工作室视频教程   |   AWR Microwave Office
          首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档


Ansoft Designer / Ansys Designer 在线帮助文档：

Schematic Editor >
   Wiring Components >
       Cross-Probing Elements           


Cross-Probing Elements

When both the Layout editor and the Schematic editor are displaying the same design, you can select one or more component instances and interface ports in both editors. Select the schematic elements or layout elements to be cross-probed. Then use one of the following methods to effect the cross-selection:

• In either editor, press <Ctrl>+K.

• In the Schematic editor, select Schematic > Cross-Probe Layout.

• In the Layout editor, select Layout > Cross-Probe Layout.

The corresponding elements in the related editor will be selected and that editor window will be brought to the front. If you select only component instances or only interface ports, then after cross-probing the primary selection in the first editor will also be the primary selection in the related editor. Note that all previous selections in the related editor will be cleared and only the cross-probed elements will be selected when the command is invoked.

Note

Changes to a design should be made from the editor that was used to create the design. For example, if a design was created using the schematic editor, it should not be modified from the layout editor. In some cases, attempts to change a schematic design from the layout editor will result in a warning such as:

 

[warning] Port Port2, ID %2, was disconnected from net 98, but it was not possible to unwire it. This must be done manually.

 

Similarly, a layout editor design can be viewed as a schematic using the cross-probing feature, but the schematic view should not be used to make changes to the design. Although an operation such as deleting a port in the schematic may successfully delete the cross-probed layout port, the operation cannot be undone in the layout editor after the schematic window has been closed (the undo attempt may cause an error).


HFSS视频教学培训教程 ADS2011视频培训教程 CST微波工作室教程 Ansoft Designer 教程

                HFSS视频教程                                      ADS视频教程                               CST视频教程                           Ansoft Designer 中文教程


　

      Copyright © 2006 - 2013   微波EDA网, All Rights Reserved    业务联系：mweda@163.com