• 首页
• HFSS教程
• ADS教程
• CST教程
• 射频工程师培训
• 微波仪器操作培训
• 天线设计培训
• 射频专业基础课

Ansoft Designer / Ansys Designer 在线帮助文档：

Nexxim Simulator >
Nexxim Component Models >
Stripline Elements >
   Tee, Reference Planes at Center       

Tee, Reference Planes at Center

Netlist Format

A tee instance has the following netlist format:

Axxx n1 n2 n3 W1=val W2=val W3=val [NSUM=val]
COMPONENT=tee SUBSTRATE=substrate_name

n1, n2, and n3 are the names of the nodes attached to the tee. The entry COMPONENT=tee identifies the element as a tee.

The entry SUBSTRATE=substrate_name identifies the stripline substrate model name selected for the design (see Selecting a Stripline Substrate). See the Stripline (SL) Substrate for information on this substrate type.

Netlist Example

A23 Port1 Port2 Port3 W1=1e-3 W2=2e-3 W3=3e-3
+ COMPONENT=TEE SUBSTRATE=SL1

where SL1, the selected layout technology or substrate type, has a definition such as:

.SUB SL1 SL( B=0.001524 Er=4.40000000000000
+ TAND=0.0200000000000000 MET1=1.72413793103448
+ T1=1.7145e-005 RGH=0mil)

Notes

1. [All substrates] The collinear lines are connected to nodes n1 and n2 and have widths W1 and W2; the perpendicular line is connected to node n3 and has width W3.

2. [All substrates] The n1, n2 reference plane is centered on the width of the line connected to node n3 (width W3).

3. [All substrates] If W1 > W2: Node n3 is collinear with W1.

4. [All substrates] If W2 > W1: Node n3 is collinear with W2.

5. [Stripline] To get accurate results, the following condition should be satisfied: B/l_g << 1, where l_g is the guide wavelength in the substrate dielectric.

                HFSS视频教程                                      ADS视频教程                               CST视频教程                           Ansoft Designer 中文教程

      Copyright © 2006 - 2013   微波EDA网, All Rights Reserved    业务联系：mweda@163.com