淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

Nexxim Simulator >
Nexxim Component Models >
Nexxim Filters >
Polynomial Band Pass Filter

Polynomial Band Pass Filter

Netlist Syntax

An instance of a polynomial band pass filter has the following Nexxim netlist syntax:

Axxx n1 n2 [FC=val] [BW=val] [GF=val] [R1=val] [X1=val] [R2=val] [X2=val] NUMER=[a0 a1 ...] DENOM=[b0 b1 ...] COMPONENT=polynomial_bandpass_filter

n1 and n2 are the nodes connected to the filter. The entry COMPONENT=polynomial_bandpass_filter is required.

**Polynomial Band Pass Filter Instance Parameters**
Parameter	Description	Units	Default
FC	Center frequency	Hz	0
BW	Bandwidth (3dB)	Hz	0
GF	Gain factor	None	1.0
R1	Resistive part of reference impedance at node 1	Ohm	50
X1	Reactive part of reference impedance at node 1	Ohm	0
R2	Resistive part of reference impedance at node 2	Ohm	50
X2	Reactive part of reference impedance at node 2	Ohm	0
a0 ... aN	Coefficients of the numerator polynomial	None	None
b0 ... bD	Coefficients of the denominator polynomial	None	None

Netlist Example

To specify the following transfer function (where coefficient a₁=0):

The netlist would specify:

A22 1 2 FC=80e6 BW=101e4 NUMER=[1 0 2] DENOM=[1 1 3]
+ COMPONENT=polynomial_bandpass_filter

Notes

1. The element is specified using a transfer function given as the ratio of two polynomials in the complex variable s. The bold brackets for the NUMER and DENOM entries are required.

The function of the device is expressed as:

GAIN ´ H(s)

The transfer function H(s) is specified by giving the coefficients:

where F = the analysis frequency and j=sqrt(-1)

2. The first coefficients in both numerator and denominator (a₀ and b₀) are constants, which must be specified even if they are zero. Thus, leading zeros are significant. In addition, intermediate zero-valued coefficients must be explicitly supplied in order to have the non-zero coefficients applied to the correct powers of s.

3. Trailing zeros are not significant, and are automatically removed.

4. Both numerator and denominator must contain at least one non-zero value..

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com