淘宝官方店     推荐课程     在线工具     联系方式     关于我们  
 
 

微波射频仿真设计   Ansoft Designer 中文培训教程   |   HFSS视频培训教程套装

 

Agilent ADS 视频培训教程   |   CST微波工作室视频教程   |   AWR Microwave Office

          首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档


Ansoft Designer / Ansys Designer 在线帮助文档:


Nexxim Simulator >
Nexxim Component Models >
Inductors >
   Inductor Device       

Inductor Device

 

Netlist Syntax

The general syntax for an inductor instance is:

Lxxxx n1 n2 [[L=]val] [TC1=val] [TC2=val] [IC=val]

[SCALE=val] [M=val] [DTEMP=val] [TNOM=val] [R=val]

n1 is the positive node and n2 is the negative node of the inductor. The current is assumed to flow from n1 through the inductor to n2.

 


Inductor Instance Parameters

Instance Parameter

Description

Unit

Default

DTEMP

Inductor and circuit temperature difference

°C

0.0

L

Inductance

Henry

0.0

M

Multiplier to simulate multiple inductors in parallel

None

1.0

R

Series resistance

Ohm

0.0

SCALE

Scale factor for inductance

None

1.0

TC1

Linear temperature coefficient

°K-1

0.0

TC2

Quadratic temperature coefficient

°K-2

0.0

TNOM

Nominal temperature

°C

25.0

IC

Initial current through inductor

Ampere

None


Inductor Instance Netlist Examples

L1 1 2 L=5PH

L2 1 2 inductor1 L=5e-12 TC1=2

L3 1 2 inductor1 L=5e-12 SCALE=1.1

L4 1 2 L=1PF

Notes

1. The label L= is optional, but the presence or absence of the L= label affects the interpretation of other unlabeled entries in the statement. The first unlabeled value is taken to be the inductance value.

2. The syntax above shows the labels TC1= and TC2= as optional, but this option depends on the presence or absence of the inductance value, labeled or unlabeled.

3. When the inductance value is present but the inductance value does not have the L= label, the next two unlabeled values are taken to be TC1, then TC2. To specify a value for TC2, either a value for TC1 must be given as well, or the label TC2= must be used.

4. When the inductance value is present with the L= label, the labels TC1= and TC2= are required.

5. When the option device_cleanup=1 is in effect, a zero-valued inductor is replaced with a short circuit, and a warning is issued.




HFSS视频教学培训教程 ADS2011视频培训教程 CST微波工作室教程 Ansoft Designer 教程

                HFSS视频教程                                      ADS视频教程                               CST视频教程                           Ansoft Designer 中文教程


 

      Copyright © 2006 - 2013   微波EDA网, All Rights Reserved    业务联系:mweda@163.com