淘宝官方店     推荐课程     在线工具     联系方式     关于我们  
 
 

微波射频仿真设计   Ansoft Designer 中文培训教程   |   HFSS视频培训教程套装

 

Agilent ADS 视频培训教程   |   CST微波工作室视频教程   |   AWR Microwave Office

          首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档


Ansoft Designer / Ansys Designer 在线帮助文档:


Nexxim Simulator >
Nexxim Component Models >
Independent Sources >
   Current Source, DC       

Current Source, DC

 

DC Current Source Netlist Format

The format for specifying a DC current source is:

Ixxxx n+ n- [DC=dc_current] [M=val] [AC acmag acphase]
[NOISEVEC=[f1,psd1, ... fn,psdn]]

n+ is the positive node and n- is the negative node of the current source. The DC value in Amperes is used for the DC operating point (default 0.0). The parameter M allows the netlist to specify multiple current sources in parallel (default 1.0).

The AC parameter specifies the AC magnitude and phase to be applied during a small-signal AC analysis. The default for acmag is 1 Amp, the default for acphase is 0 degrees.

 


DC Current Source Parameters

Parameter

Description

Unit

Default

acmag

Magnitude for AC analysis

Amp

1.0

acphase

Phase for AC analysis

Degree

0.0

DC

DC current value

Amp

0.0

M

Multiplier for simulating multiple parallel current sources

None

1.0

NOISEVEC

List of shot noise frequencies (f1...fn) and corresponding noise power spectral densities (psd1...psdn), in pairs.

The sequence of frequencies must be monotonically non-decreasing.

Hertz,
Volt2/Hertz

None


DC Current Source Netlist Example

I5 34 27 DC=1e-2




HFSS视频教学培训教程 ADS2011视频培训教程 CST微波工作室教程 Ansoft Designer 教程

                HFSS视频教程                                      ADS视频教程                               CST视频教程                           Ansoft Designer 中文教程


 

      Copyright © 2006 - 2013   微波EDA网, All Rights Reserved    业务联系:mweda@163.com