淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

Nexxim Simulator >
   Controlling Nexxim Output >
       Netlist Design Output Control >
           Netlist PRINT Statements

Netlist PRINT Statements

A netlist can use one or more .PRINT statements to specify the outputs from particular types of analysis.

Warning

By default, Nexxim stores all intermediate values for all nodes. If you do not use a .PRINT statement, all node voltages and branch currents are retained so that they can be output to the results file. With large circuits or analyses, the amount of data to be stored can cause the simulation to slow down, or even to exceed memory limits (usually a fatal error for Designer/Nexxim). .PRINT statements specify which nodes/values are to be retained, allowing Nexxim to discard all other values when they are no longer needed. Use of .PRINT statements can significantly reduce memory usage. Although the range of output values may be limited, in those cases where memory is an issue a .PRINT statement may be required to allow the computation to complete successfully.

Note

.PROBE statements in imported netlists are internally converted to .PRINT statements.

There are three forms of the .PRINT statement, one for simple circuit values, one for expressions involving circuit values, and one for the output of values calculated internally by selected device models. The output specification for all three PRINT statement types can use wildcard characters.

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com