Modify Edge Location
Picks  Pick Lists Selected Edges Modify
This dialog box allows you to change the coordinates of a picked edge
which has previously been selected from the list box in the List of Selected Edges dialog
box.
You may specify a translation vector which will be applied to the edge
start and end point coordinates in order to obtain the new edge location.
This translation vector is specified either in global or in local coordinates,
depending on which system is currently active.
DX/DY/DZ
Specify valid
for the components of the translation vector which will be used to transform
the edge point coordinates. Since this translation vector is specified
in global coordinates, these settings are only visible when the global
coordinate system is currently active.
DU/DV/DW
Specify valid
for the components of the translation vector which will be used to transform
the edge point coordinates. Since this translation vector is specified
in local coordinates, these settings are only visible when a local coordinate
system is currently active.
Keep original item
This check box allows you to specify whether
the original edge shall be kept or skipped when the translation is applied.
OK
Press this button to apply the specified translation
to the selected edges. The display of the edges in the main view will
be updated immediately.
Cancel
Closes this dialog box without performing any
further action.
Help
Shows this help text.
See also
Pick
Points, Edges or Faces Overview,
List of Selected Edges.
HFSS视频教程
ADS视频教程
CST视频教程
Ansoft Designer 中文教程
|
淘宝官方店 
