Thermal Loss Distribution Specials
Sources and Loads Thermal LossesSpecials
Consider Surface losses on boundaries
Select the boundaries, where surface losses
should be taken into account.
Default conductivity for PEC
Define the default surface conductivity for
the surface loss calculation on PEC surfaces. This setting has a great
influence on the calculated loss power.
Minimum relative conductance for loss mapping
This settings defines the relative minimum conductance
of a region where loss distributions are taken into account. Especially
for surface losses this setting is important, to prevent artificial heating
on curved surfaces.
The minimum conductance value is calculated
by multiplying the entered relative value (between 0 and 1) with the maximum
conductance value used for a certiain example:
Example:
Three thermal conductance values have been used:
If a relative value
of 0.01 is specified, losses are only taken into account within regions
with a thermal conductance of more than 401 * 0.01 = 4.01 W / K / m. In
this case this means that losses which have been mapped to air or rubber
regions are not used for the thermal simulation.
OK
Accepts the changes and closes
the dialog.
Cancel
Closes this dialog box without
performing any further action.
Help
Shows this help text.
HFSS视频教程
ADS视频教程
CST视频教程
Ansoft Designer 中文教程
|
淘宝官方店 
