PCBS Block Properties - Solver

Navigation Tree: Blocks<Block Name>PropertiesSolver

This dialog page contains block specific solver settings of CST PCB STUDIO blocks or SimLab TL/PEEC File blocks.

Use differential cable ports

This control enables the use of differential ports for cable models. Enable this feature if the connected components of at least one cable port do not refer to the ideal ground.

Use Irradiation Data

This checkbox is active when the model was created for emi analyses (button in modelling dialog 'Create model for emi analysis'). If it is checked irradiated fields determined in CST MICROWAVE STUDIO or in CST MICROSTRIPES can be considered for an AC simulation.

Create Radiation Data

This checkbox is active when the model was created for emi analyses (button in modelling dialog 'Create model for emi analysis'). If it is checked an AC task will generate an equivalent current and field source which can be imported into CST MICROWAVE STUDIO or CST MICROSTRIPES. See the AC Simulation Task page for details.

Simulation model

Here, you can choose the model for the selected block. The following models are available:

Standard model

The standard model represents any associated PEEC or TL model by an RLC network. Skin effect- and/or dielectric losses are taken into account as specified in the associated CST PCB STUDIO project. The standard model is often more accurate, especially if many terminals are involved.

Dispersive model

If this solver option is checked, model order reduction is applied to any associated PEEC or TL model. For large PEEC models, the dispersive model tends to be faster than the standard model.

OK

Accepts your settings and leaves the dialog box.

Cancel

Closes this dialog box without performing any further action.

Apply

Performs your settings without leaving the dialog box.

Help

Shows this help text.

See also

Block Overview, AC Simulation Task