• 首页
• HFSS教程
• ADS教程
• CST教程
• 射频工程师培训
• 微波仪器操作培训
• 天线设计培训
• 射频专业基础课

Ansoft Designer / Ansys Designer 在线帮助文档：

Schematic Editor >
   Miscellaneous Schematic Operations >
       Setting Up Multi-Page Schematics           

Setting Up Multi-Page Schematics

Setting up multi-page schematics involves two activities: adding pages, and adding and naming page connectors to establish electrical connectivity between them as necessary.

To add a page or pages to a schematic:

1. Open the schematic to which you want to add a new page or pages.

2. Click the New Page tab.

You are now editing the new page, 2. Repeat as necessary to add additional pages.

To establish a common electrical connection between pages, place a page connector on each page that will share the connection. To do this on each page:

1. Select the page.

2. Do either of the following:

• On the Draw menu, click Page Connector.

• On the Schematic Draw toolbar, click the Page connector icon.

The cursor, now associated with a page connector symbol for placement, moves to the center of the schematic window. To place the connector, click at the desired location.

If Multiple Placement is turned on for page connectors in the Schematic Options dialog box, you can place additional connectors by clicking at additional locations. To stop placing page connectors during multiple placement, do either of the following:

• Press ENTER, the SPACEBAR, BACKSPACE, or ESC on your keyboard.

• Right-click, and then select Place and Finish, Finish, Cancel, or Back.

Within a design and at the same hierarchical level, all page connectors with the same name act as a common electrical connection. Therefore, once you have finished placing page connectors that you want to be electrically common, you must ensure that they all have the same name. To change the name of a page connector, do either of the following:

• Open its Properties dialog by double-clicking the connector’s schematic symbol, type a new name into the Value cell for the port’s Name property, and then click OK.

• Click the connector. In the Parameters tab of the Properties window, click the Value cell for the NetName parameter, type the new name, and press ENTER.

                HFSS视频教程                                      ADS视频教程                               CST视频教程                           Ansoft Designer 中文教程

      Copyright © 2006 - 2013   微波EDA网, All Rights Reserved    业务联系：mweda@163.com