淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

Optimetrics >
Setting up a Parametric Analysis >
Overriding a Variable Value in a Parametric Setup

Overriding a Variable Value in a Parametric Setup

If you choose not to sweep a variable, Designer uses the variable’s current value set for the nominal design when it solves the parametric setup. To override the current variable value for a parametric setup:

1. In the Setup Sweep Analysis dialog box, click the General tab.

Under Starting Point, all of the current independent design variable values are listed.

2. Click the Value text box of the variable with the value you want to override for the parametric setup.

3. Type a new value in the Value text box, and then press Enter.

The Override option is now selected. This indicates that the value you entered will be used for the parametric setup. For this parametric setup, the new value will override the current value in the nominal design.

Note

Alternatively, you can select the Override option first, and then type a new variable value in the Value text box.

4. Optionally, click a new unit in the Units text box.

To revert to the current variable value, clear the Override option.

Warning

Variable values must be single real numbers, or expressions that evaluate to single real numbers. Complex numbers cannot be used as the values of variables in any optimetric analysis.

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com