A possible reason for CST suspension after a couple of successful runs
文章来源: 互联网 录入: mweda.com
This possible reason comes from a window file named as WB9ENT.OCX. The corresponding HKEY location is at
HKEY_LOCAL_MACHINE\SOFTWARE\CLASSES\CLSID\{B20ABC73-3858-11D6-8F7F-0000861EF01D}:
The key value should be 1. InprocServer32=C:\WINDOWS\System32\WB9ENT.OCX
微波EDA (www.mweda.com) 网友回复:
-
网友回复
2. ToolboxBitmap32=C:\Windows\System32\WB9ENT.OCX
If these two key values in your registry table are different from ones given above, your CST running may be suspended at the moment you want to enter modeler.
The WB9ENT.OCX of version of 2008 was tested only. The different key values are resulted from installation of the other softwares which require this file to run, such as Statistica,Femap and et.al. If you once installed these softwares into your computer, they are the most suspected one for CST suspension. Good luck.
申明:网友回复良莠不齐,仅供参考。如需专业解答,推荐学习李明洋老师的CST培训视频,或咨询本站专家。
-
CST中文视频教程,资深专家讲解,视频操作演示,从基础讲起,循序渐进,并结合最新工程案例,帮您快速学习掌握CST的设计应用...【详细介绍】
推荐课程
-
7套中文视频教程,2本教材,样样经典
-
国内最权威、经典的ADS培训教程套装
-
最全面的微波射频仿真设计培训合集
-
首套Ansoft Designer中文培训教材
-
矢网,频谱仪,信号源...,样样精通
-
与业界连接紧密的课程,学以致用...
-
业界大牛Les Besser的培训课程...
-
Allegro,PADS,PCB设计,其实很简单..
-
Hyperlynx,SIwave,助你解决SI问题
-
现场讲授,实时交流,工作学习两不误